ASTM C1036 PDF

Flat Glass Inspection Criteria per ASTM C – 11/ASTM C Terminology. crush:lightly pitted condition with a dull gray appearance. dig:deep, short. Find the most up-to-date version of ASTM C at Engineering This standard is issued under the fixed designation C ; the number ASTM Standards: 2 cut size, n—glass ordered cut to its final intended size.

Author: Arajind Gumuro
Country: Nepal
Language: English (Spanish)
Genre: Politics
Published (Last): 9 September 2013
Pages: 164
PDF File Size: 10.79 Mb
ePub File Size: 11.30 Mb
ISBN: 596-9-18688-584-5
Downloads: 32425
Price: Free* [*Free Regsitration Required]
Uploader: Maukazahn

If a blemish is detected, refer to Tables 3 and 4 for evaluation criteria.

This abstract is a brief summary of the referenced standard. None allowed None allowed None allowed None allowed Allowed Allowed with a minimum separation of mm 24 in.

Flat Glass Inspection Criteria per ASTM C 1036 – 11/ASTM C 1048-12

The monolithic flat glass shall be supplied as cut sizes or stock sheets. Check with the manufacturer for thickness and dimensional tolerances on random Pattern P3 and special Pattern P4. Glass intended to be used primarily for architectural glazing products including: ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend.

  IN THE NAME OF EUGENICS KEVLES PDF

Table 3 does not apply to glass thicker than Typical minimum thickness for DST is 0. Opening in the mesh shall not exceed 16 mm 5? A superscript epsilon e indicates an editorial change since the last revision or reapproval.

It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. The allowable blemish sizes listed in Table 3 include associated distortion for Q1 and Q2, but Q3 and Q4 do not include associated distortion. Table 9 does not apply to glass thicker than The minimum separation distance between blemishes is determined by the minimum separation required for the larger of the two blemishes.

AAMA – Glass Standards and Guidelines

Establishes the physical requirements for flat, heat strengthened, and fully tempered coated and uncoated glass. C — 06 Standard Speci?

Glass strength, overall bow, localized bow, dimension, hole, notches and cut-out tolerances and product labeling. Type II glass shall have clear and c1306 classes while Type I glass shall only have the clear class. This standard has been approved for use by agencies of the Department of Defense.

  CHRISTADELPHIAN STATEMENT FAITH PDF

Refer to Table 5 for evaluation criteria. See Table 1 for acceptance criteria. Different test methods for Type I glass shall be performed in order to determine the following properties: Medium 75 mm 3 in. Discoloration and ast distortion of wire are permissible.

Glass Standards and Guidelines. F Allowed with a minimum separation of mm 60 in. V1036 None allowed None allowed None allowed See 6. The values given in parentheses are for information only.

For glass thicker than 6. The lower of the two interference angles c136 shall be used to compare to the evaluation criteria in Table 6. Allowed with a minimum separation of mm 60 in. None allowed None allowed Q2 Quality 2 Distribution Allowed with a minimum separation of mm 48 in.

NOTE 4—Patterned glass can vary slightly in both con? Heavy mm 6 in. As for the type II f1036 the following properties shall be determined after different tests: